CONSULT-II Functions (IPDM E/R)

CONSULT-II Functions (IPDM E/R):

CONSULT-II Functions (IPDM E/R)
CONSULT-II can display each diagnostic item using the following diagnostic test modes: work support, self-diagnostic results, data monitor and active test through data reception and command transmission via the IPDM E/R CAN communication line.

CONSULT-II OPERATION

CAUTION: If CONSULT-II is used with no connection of CONSULT-II CONVERTER, malfunctions might be detected in self-diagnosis depending on control unit which carry out CAN communication.




1. With the ignition switch OFF, connect CONSULT-II and CONSULT-II CONVERTER to the data link connector, then turn the ignition switch ON.




2. Touch "START (NISSAN BASED VHCL)".




3. Touch "IPDM E/R" on "SELECT SYSTEM" screen.
If "IPDM E/R" is not displayed, print "SELECT SYSTEM" screen, then refer to Information Bus, "Precautions When Using CONSULT-II".




4. Select the desired part to be diagnosed on the "SELECT SYSTEM" screen.

SELF-DIAGNOSTIC RESULTS
Refer to "SELF-DIAG RESULTS".

DATA MONITOR

Operation Procedure
1. Touch "DATA MONITOR" on "SELECT DIAG MODE" screen.




2. Touch "ALL SIGNALS", "MAIN SIGNALS" or "SELECT FROM MENU" on the "DATA MONITOR" screen.
3. Touch "START".
4. Touch the required monitoring item on "SELECT ITEM MENU". In "ALL SIGNALS", all items are monitored. In "MAIN SIGNALS", predetermined items are monitored.
5. Touch "RECORD" while monitoring to record the status of the item being monitored. To stop recording, touch "STOP".




All Items, Main Items, Select Item Menu

ACTIVE TEST

Operation Procedure
1. Touch "ACTIVE TEST" on "SELECT DIAG MODE" screen.
2. Touch item to be tested, and check operation.
3. Touch "START".




4. Touch "STOP" while testing to stop the operation.