Initial Inspection (Preliminary Check)

If initialization has not been performed, automatic drive positioner will not operate.

PROCEDURE A
1. Insert key in the ignition key cylinder. (Ignition switch is in "OFF" position.)
2. Open -> close -> open driver side door. (Do not perform with the door switch operation.)
3. End

PROCEDURE B
1. Drive the vehicle at more than 25 km/h (16 MPH).
2. End

After performing preliminary check, go to symptom chart. Symptom Related Diagnostic Procedures
Before starting trouble diagnosis, perform preliminary check, "WORK FLOW". Symptom numbers in the symptom chart correspond with those of preliminary check.