Preliminary Check

*1: After reconnecting battery cable, perform initialization procedure A or B.
If initialization has not been performed, automatic drive positioner will not operate.

PROCEDURE A
1. Insert key in the ignition key cylinder. (Ignition switch is in "OFF" position.)
2. Open -> close -> open driver side door. (Do not perform with the door switch operation.)
3. End

PROCEDURE B
1. Drive the vehicle at more than 25 km/h (16 MPH).
2. End

After performing preliminary check, go to symptom chart.

Before starting trouble Diagnosis, perform preliminary check. Symptom numbers in the symptom chart correspond with those of preliminary check.