Automatic Drive Positioner

AUTOMATIC DRIVE POSITIONER

System Description
- The system automatically moves the driver seat and steering wheel to facilitate entry/exit to/from the vehicle by connecting the BCM (Body Control Module) to the driver seat control unit the multiple communication line. The BCM can also store the optimum driving positions (driver seat, steering wheel and door mirror position) for 2 people. If the driver is changes, one-touch operation allows changing to the other driving position.
- The settings (ON/OFF) of the automatic tilt steering wheel and sliding seat (Entry/exiting function) at entry/exit can be changed as desired, using the display unit in the center of the instrument panel.

MANUAL OPERATION
The driving position (seat position, steering wheel position, door mirror position) can be adjusted with the power seat switch or ADP (Automatic Drive Positioner) steering switch.

NOTE:
- The seat and steering wheel position can be manually operated with the ignition switch OFF.
- The door mirrors can be manually operated with the ignition switch in either ACC or ON.




AUTOMATIC OPERATION

NOTE:
- Disconnecting the battery erases the stored memory.




- After connecting the battery, insert the key into the ignition cylinder and turn the driver door switch ON (open) -> OFF (close) -> ON (open), the Entry/exiting function becomes possible.
- During automatic operation, if the ignition switch is turned ON -> START, the automatic operation is suspended. When the ignition switch returns to ON, it resumes.




FAIL-SAFE MODE
When the ignition switch is in the ON position, if any of the parts (indicated in the following chart) move more than the specified amount within a period "T" when no "ON" input is sent from any of the switches (indicated in the following chart), or an output from the automatic drive positioned is not produced, an output malfunction is sensed. Motor operation will be suspended automatically, and all automatic operations will be ineffective. (In this case, the motor will not operate manually).

CANCEL OF FAIL-SAFE MODE
- The mode is cancelled when the selector lever is shifted to P-position from any other position.
- The mode can be cancelled with CONSULT-II.




MEMORY STORING
Store the 2 driving positions and shifts to the stored driving position with the memory switch.




MEMORY SWITCH OPERATION

NOTE:
1. Do not setting change as it will not operate. refer to "SETTING CHANGE FUNCTION"
2. Automatic turnout function will be performed.




3. The driver's seat position and steering adjustment (see the Table) operate simultaneously in the order of priority.
The mirror moves when the ignition switch is in ACC.

TURNOUT OPERATION
At exit, the seat and steering wheel are automatically moved to the turnout position.
- Seat: moves backward.




- Steering wheel: tilted upward and extended fully.

NOTE: The seat sliding, steering wheel tilt, and telescoping are moved to the turnout position simultaneously.




RETURN OPERATION
When the seat and steering wheel are on the exiting positions, the following operation moves the seat and steering wheel to the previous position before the turnout operation.

NOTE: The seat sliding, steering wheel tilt, and telescoping return to the original positions simultaneously.

REAR POWER SEAT TURNOUT OPERATION
Rear power seat moves back ward with driver' s seat at the same time in case turnout operation.