Transmission Position Sensor/Switch: Service and Repair

Parking Components





COMPONENTS

REMOVAL
1. Drain ATF through drain plug.
2. Remove exhaust front tube and center muffler with power tool. Refer to "Removal and Installation".
3. Remove propeller shaft. Refer to "Removal and Installation".





4. Remove engine rear member with power tool. Refer to "Removal and Installation".





5. Remove tightening bolts for output shaft & companion flange complement and transmission case.(With terminal bracket)





6. Tap output shaft & companion flange complement with soft hammer.





7. Remove output shaft & companion flange complement from transmission assembly (With needle bearing)





8. Remove parking actuator support from output shaft & companion flange complement.





9. Remove parking pawl, parking pawl shaft and return spring from output shaft & companion flange complement.





10. Remove return spring from parking pawl.

INSPECTION








^ If the contact surface on parking actuator support, parking pawl, etc. has excessive wear, abrasion, bend, or any other damage, replace the components.

INSTALLATION





1. Install return spring in parking pawl.





2. Install parking pawl and pawl shaft in output shaft & companion flange complement.





3. Install parking actuator support in output shaft & companion flange complement.





4. Apply recommended sealant (Genuine Anaerobic Liquid Gasket or equivalent. Refer to "Recommended Chemical Products and Sealants".) to output shaft & companion flange complement as shown in illustration.

CAUTION: Complete remove all moisture, oil and old sealant, etc. From the transmission case and output shaft & companion flange complement mounting surfaces.





5. Install output shaft & companion flange complement in transmission assembly.





6. Tighten output shaft & companion flange complement mounting bolts to specified torque. (Because terminal bracket is tightened together with output shaft & companion flange, it should be installed before procedure 5.)

CAUTION: Do not reuse self-sealing bolt.

Output shaft & companion flange complement mounting bolt: 52 Nm (5.3 kg-m, 38 ft. lbs.)
Self-sealing bolt: 61 Nm (6.2 kg-m, 45 ft. lbs.)





7. Install engine rear member with power tool. Refer to "Removal and Installation".
8. Install propeller shaft. Refer to "Removal and Installation"
9. Install exhaust front tube and center muffler with power tool. Refer to "Removal and Installation".
10. Pour ATF into transmission assembly. Refer to "A/T FLUID".
^ After completing installation, check fluid leakage and fluid level of transmission assembly. Refer to "Checking A/T Fluid".