With Manufacturer's Scan Tool (CONSULT II)

INSPECTION PROCEDURE
1. Turn ignition switch OFF.




2. Connect CONSULT-II and CONSULT-II CONVERTER to data link connector, which is blocated under LH dash panel near the fuse box cover.
3. Turn ignition switch ON.




4. Touch "START(NISSAN BASED VHCL)".




5. Touch "ENGINE".
If "ENGINE" is not indicated, go to GI-38, "CONSULT-II Data Link Connector (DLC) Circuit". Data Link Connector Schematic




6. Perform each diagnostic test mode according to each service procedure.
For further information, see the CONSULT-II Operation Manual.