Roof and Associated Components: Service and Repair

ROOF SIDE MOLDING




Removal and Installation

REMOVAL
1. Remove molding front edge from body side clip.
2. Take off front edge of molding and remove rear end molding.
3. Remove front side clip and rear side clip.

INSTALLATION
Install in the reverse order of removal paying attention to the following.
1. Apply double-faced adhesive tape and apply primer and adhesive on front edge of molding at standard extent (as indicated with [C] and [D]).
2. When molding clip with damage after removing molding is found clip is exchange.

CAUTION: Be careful not to damage the body painting when you use the cutter and tool tool.