P1752

P1752 INPUT CLUTCH SOLENOID VALVE

Description
^ The Input clutch solenoid valve is controlled by the TCM in response to signals sent from the PNP switch, vehicle speed sensor and accelerator pedal position sensor (throttle position sensor). Gears will then be shifted to the optimum position.
^ The Input clutch solenoid valve controls the input clutch control valve in response to a signal sent from the TCM.

DTC Logic

DTC DETECTION LOGIC

P1752:

DTC CONFIRMATION PROCEDURE

CAUTION: Always drive vehicle at a safe speed.

NOTE: If "DTC CONFIRMATION PROCEDURE" has been previously performed, always turn ignition switch OFF and wait at least 10 seconds before performing the next test.

After the repair, perform the following procedure to confirm the malfunction is eliminated.

1. CHECK DTC DETECTION

With CONSULT-III
1. Start the engine.
2. Select "DATA MONITOR".
3. Drive vehicle and maintain the following conditions for at least 5 consecutive seconds.
ACCELE POSI: 1.5/8 - 2.0/8
GEAR: "3" => "4" (I/C ON/OFF)
SLCT LVR POSI: "D" position
Driving location: Driving the vehicle uphill (increased engine load) will help maintain the driving conditions required for this test.

With GST
Follow the procedure "With CONSULT-III".
Is "P1752 I/C SOLENOID/CIRC" detected?
YES >> Go to TM-153, "Diagnosis Procedure".
NO >> Check Intermittent incident. Refer to, "Intermittent Incident". Testing and Inspection

Diagnosis Procedure

1. CHECK TCM POWER SUPPLY AND GROUND CIRCUIT
Check TCM power supply and ground circuit. Refer to, "Diagnosis Procedure".
Is the inspection result normal?
YES >> Replace the control valve with TCM.
NO >> Repair or replace damaged parts.