Removal and Installation of Instrument Panel

INSTRUMENT PANEL : Removal and Installation

REMOVAL




1. Remove cup holder.
- Pull up to remove cup holder.

2. Remove switch finisher.
- Remove switch finisher fixing screws.
- Disconnect harness connector.




3. Remove A/T console finisher.
- Place the selector lever in [D] position.
- Remove selector lever knob.
- Lift up backside and pull back.
- Disconnect harness connectors.




4. Remove cluster lid C.
- Remove cluster lid C fixing screws.
- Pull back cluster lid C.
- Disconnect harness connectors.




5. Remove console rear finisher.
- Insert a remover into upper space of console rear finisher.
- Pull back console rear finisher.

6. Remove center console fixing screws with power tool.
- Pull up center console.
- Disconnect harness connector.




7. Remove glove box.
- Remove damper pin to left side.
- Pull up glove box.

8. Remove instrument passenger lower cover.
- Pull downward, disengaged pawls.
- Pull back instrument passenger lower cover.
- Disconnect harness connector.

9. Remove instrument side finisher (RH).
- Insert a remover into lower space.
- Pull the instrument side finisher (RH) crosswise.

10. Remove glove box cover with power tool.




11. Remove instrument finisher B.
- Remove instrument finisher B fixing screws.
- Insert a remover into right space.

12. Remove front pillar garnish (LH/RH).




13. Remove instrument side finisher (LH).
- Insert a remover into lower space.
- Pull the instrument side finisher (LH) crosswise.




14. Remove instrument driver lower panel.
- Remove hood opener mounting bolt.
- Pull back.
- Disconnect harness connectors.




15. Remove instrument finisher A.
- Insert a remover into upper space.
- Pull back instrument finisher A.




16. Remove instrument finisher C.
- Insert a remover into upper space.
- Pull back instrument finisher C.




17. Remove cluster lid A
- Pull back.

18. Remove combination meter.
19. Remove steering column cover with power tool.
20. Remove upper ventilator grille.




21. Remove center ventilator grille.
- Remove center ventilator grille fixing screws.
- Insert a remover into rear lower space.
- Pull up.

22. Remove multifunction switch.
23. Remove front display unit.
24. Remove AV control unit.
25. Remove front passenger air bag module mounting bolt and disconnect harness connector.




26. Remove side ventilator grille (RH/LH).
- Insert a remover into lower space.
- Pull back.




27. Remove front defroster grille.
- Insert a remover into back space.
- Pull up front defroster grille.
- Disconnect harness connector.

28. Remove instrument panel assembly fixing screws, and then remove instrument panel assembly.

CAUTION: When removing instrument panel, 2 workers are required so as to prevent it from dropping.

INSTALLATION
Install in the reverse order of removal.

CAUTION:
- To install, confirm locating pins on back of instrument panel are completely inserted into holes on vehicle.
- Do not leave harness stuck when installing.