Receiver Dryer: Service and Repair

REFRIGERANT LINES


VQ35HR : Removal and Installation of Liquid Tank


DISASSEMBLY AND ASSEMBLY






REMOVAL
1. Remove condenser. Refer to Service and Repair.
2. Clean liquid tank and its surrounding area, and remove dust and rust from liquid tank.

CAUTION:
Be sure to clean carefully.





3. Remove mounting bolts from liquid tank.
4. Lift liquid tank bracket upward. Remove liquid tank bracket from protruding part of condenser.





5. Slide liquid tank upward, and then remove liquid tank.

CAUTION:
Cap or wrap the joint of the A/C piping and liquid tank with suitable material such as vinyl tape to avoid the entry of air.

INSTALLATION
Install liquid tank, and then install liquid tank bracket on condenser.






CAUTION:
- Check liquid tank bracket is securely installed at protrusion of condenser. (Check liquid tank bracket does not move to a position below center of liquid tank.)
- Replace O-rings of the A/C piping with new ones. Then apply compressor oil to them when installing.
- Check for leakages when recharging refrigerant.