Check Seat Memory and Set Switch Circuit

AUTOMATIC DRIVE POSITIONER


Check Seat Memory and Set Switch Circuit

1.CHECK FUNCTION
With CONSULT-III
With "SET SW, MEMORY SW1, MEMORY SW2" on the DATA MONITOR, operate the switch to check ON/OFF operation.





Without CONSULT-III
1. Turn ignition switch OFF.
2. Check voltage between automatic drive positioner control unit connector and ground.










OK or NG
OK - Seat memory switch circuit is OK.
NG - GO TO 2.
2.CHECK SEAT MEMORY SWITCH
1. Disconnect seat memory switch connector.
2. Operate the setting switch and seat memory switch.
3. Check continuity between seat memory switch as follows.










OK or NG
OK - GO TO 3.
NG - Replace seat memory switch.
3.CHECK HARNESS CONTINUITY
1. Disconnect automatic drive positioner control unit connector.





2. Check continuity between automatic drive positioner control unit connector and seat memory switch connector.





3. Check continuity between automatic drive positioner control unit connector and ground.





OK or NG
OK - GO TO 4.
NG - Repair or replace harness.
4.CHECK SEAT MEMORY SWITCH GROUND CIRCUIT





Check continuity between seat memory switch connector and ground.





OK or NG
OK - Replace automatic drive positioner control unit.
NG - Repair or replace harness.