Check Tilt Sensor Circuit

AUTOMATIC DRIVE POSITIONER


Check Tilt Sensor Circuit

1.CHECK TILT SENSOR
With CONSULT-III
With "TILT SEN" on the DATA MONITOR, operate the tilt switch to make sure voltage changes.





Without CONSULT-III
1. Turn ignition switch OFF.
2. Check voltage between automatic drive positioner control unit connector and ground.










OK or NG
OK - Tilt sensor circuit is OK.
NG - GO TO 2.
2.CHECK HARNESS
1. Disconnect automatic drive positioner control unit connector and tilt sensor connector.
2. Check continuity harness between automatic drive positioner control unit connector and tilt sensor connector.





3. Automatic drive positioner control unit connector and ground.










OK or NG
OK - GO TO 3.
NG - Repair or replace harness.
3.CHECK AUTOMATIC DRIVE POSITIONER CONTROL UNIT OUTPUT
1. Connect automatic drive positioner control unit connector.
2. Check voltage between automatic drive position control unit connector and ground.










OK or NG
OK - Replace telescopic sensor.
NG - Replace automatic drive positioner control unit.