Check Mirror Sensor Circuit

REVERSE INTERLOCK DOOR MIRROR SYSTEM


Check Mirror Sensor Circuit

1.CHECK MIRROR SENSOR INSPECTION
With CONSULT-III
Check the voltage on (MIR/SE LH R�L, MIR/SE LH U�D, MIR/SE RH R�L, MIR/SE RH U�D) in the DATA
MONITOR.





Without CONSULT-III
1. Turn ignition switch ON.
2. Check voltage between automatic drive positioner control unit connector and ground.










OK or NG
OK - Mirror sensor LH circuit is OK.
NG - GO TO 2.
2.CHECK MIRROR SENSOR POWER SUPPLY 1
Check voltage between door mirror connector and ground.










OK or NG
OK - GO TO 5.
NG - GO TO 3.
3.CHECK MIRROR SENSOR POWER SUPPLY 2
1. Turn ignition switch OFF.
2. Disconnect door mirror connector.
3. Turn ignition switch ON.
4. Check voltage between automatic drive positioner control unit connector and ground.










OK or NG
OK - GO TO 4.
NG - Replace automatic drive positioner control unit.
4.CHECK HARNESS CONTINUITY 1
1. Turn ignition switch OFF.
2. Disconnect automatic drive positioner control unit connector.
3. Check continuity between automatic drive positioner control unit connector and door mirror connector.










4. Check continuity between automatic drive positioner control unit connector and ground.





OK or NG
OK - Check the condition of harness and connector.
NG - Repair or replace harness.
5.CHECK MIRROR SENSOR GROUND 1
1. Turn ignition switch OFF.
2. Disconnect door mirror connector.
3. Check continuity between door mirror connector and ground.










OK or NG
OK - GO TO 8.
NG - GO TO 6.
6.CHECK MIRROR SENSOR GROUND 2
Check continuity between automatic drive positioner control unit connector and ground.










OK or NG
OK - GO TO 7.
NG - Replace auto drive positioner control unit.
7.CHECK HARNESS CONTINUITY 2
1. Disconnect automatic drive positioner control unit connector.
2. Check continuity between automatic drive positioner control unit connector and door mirror connector.










3. Check continuity between automatic drive positioner control unit connector and door mirror connector.





OK or NG
OK - Check the condition of the harness and connector.
NG - Repair or replace harness between automatic drive positioner control unit and door mirror.
8.CHECK HARNESS CONTINUITY 3
1. Disconnect automatic drive positioner control unit connector and door mirror connector.
2. [Door mirror LH]
- Check continuity between automatic drive positioner control unit connector and door mirror LH connector.










- Check continuity between automatic drive positioner control unit connector and ground.





3. [Door mirror RH]
- Check continuity between automatic drive positioner control unit connector and door mirror RH connector.










- Check continuity between automatic drive positioner control unit connector and ground.





OK or NG
OK - Check the condition of harness and connector.
NG - Repair or replace harness between automatic drive positioner control unit and door mirror connector.