Check Mirror Switch Circuit

REVERSE INTERLOCK DOOR MIRROR SYSTEM


Check Mirror Switch Circuit

1.CHECK MIRROR SWITCH SIGNAL
With CONSULT-III
Check the operation on "(MIR CON SW�UP/DN) and (MIR CON SW�RH/LH) in the DATA MONITOR.





Without CONSULT-III
1. Turn ignition switch to ON position.
2. Check voltage between automatic drive positioner control unit connector and ground.










OK or NG
OK - Mirror switch circuit is OK.
NG - GO TO 2.
2.CHECK HARNESS CONTINUITY
1. Turn ignition switch OFF.
2. Disconnect automatic drive positioner control unit and door mirror remote control switch connector.
3. Check continuity between automatic drive positioner control unit connector and door mirror remote control switch connector.










4. Check continuity between automatic drive positioner control unit connector and ground.





OK or NG
OK - GO TO 3.
NG - Repair or replace harness.
3.CHECK DOOR MIRROR SWITCH
Check door mirror remote control switch.










OK or NG
OK - GO TO 4.
NG - Replace door mirror remote control switch.
4.CHECK AUTOMATIC DRIVE POSITIONER CONTROL UNIT OUTPUT SIGNAL
1. Connect automatic drive positioner control unit connector.
2. Turn ignition switch ON.
3. Check voltage between automatic drive positioner control unit and ground.










OK or NG
OK - Check the condition of harness and connector.
NG - Replace automatic drive positioner control unit.