Scan Tool Testing and Procedures

TROUBLE DIAGNOSIS


CONSULT-III Function (ALL MODE AWD/4WD)


FUNCTION
CONSULT-III can display each diagnostic item using the diagnostic test modes shown following.






SELF-DIAG RESULT MODE
Drive at 30 km/h (19 MPH) or more for approximately 1 minute before performing the self-diagnosis.

Display Item List

Display Item List:

How to Erase Self-Diagnostic Results
Before erasing DTC memory, start the engine and drive at 30 km/h (19 MPH) or more for approximately 1 minute. Check that ABS warning lamp turns OFF.

NOTE:
When 4WD warning lamp is ON with system malfunction of DTC "C1203", 4WD warning lamp may not turned
OFF unless running the vehicle at 30 km/h (19 MPH) or more for a minute and check ABS warning lamp is turned OFF. Then turn ignition key OFF, and start engine again.

DATA MONITOR MODE

Display Item List






ACTIVE TEST MODE

Description
Use this mode to determine and identify the details of a malfunction based on self-diagnostic results or data monitor. AWD control unit gives drive signal to actuator with receiving command from CONSULT-III to check operation of actuator.

Test Item