Removal and Installation

OIL PAN


Removal and Installation


REMOVAL
1. Drain ATF through drain plug.
2. Remove exhaust mounting bracket with a power tool. Exploded View.





3. Disconnect heated oxygen sensor 2 connectors (A).

White arrow: Vehicle front
Black arrow: Bolt

4. Remove heated oxygen sensor 2 harness (B) from clips (1).
5. Remove bracket (2) from A/T assembly. Exploded View.





6. Remove clips (1).

White arrow: Vehicle front
Black arrow: Oil pan mounting bolt

7. Remove oil pan (2) and oil pan gasket.
8. Remove magnets from oil pan.

INSTALLATION
Note the following, and install in the reverse order of removal.

CAUTION:
- Clean foreign materials (gear wear particles) that adhere on the inside of the oil pan and on the magnet, and then assembly.
- Completely remove all moisture, oil and old gasket, etc. from oil pan gasket mounting surface of transmission case and oil pan.
- Never reuse oil pan gasket and oil pan mounting bolts.
- Install oil pan gasket in the direction to align hole position.
- Never reuse drain plug and drain plug gasket. In addition, install new drain plug and drain plug gasket after adjustment of A/T fluid filling.





- Tighten the oil pan mounting bolts to the specified torque in the numerical order as shown in the figure after temporarily tightening them.

White arrow: Vehicle front