Removal and Installation

ACCELERATOR CONTROL SYSTEM


Removal and Installation


REMOVAL
1. Disconnect accelerator pedal position sensor harness connector.
2. Remove front kicking plate and dash side finisher. Locations Service and Repair.
3. Remove the cap and the inside mounting nut, and then disassemble the accelerator pedal pad from the floor carpet.





4. Press the pin (1) with long-nose pliers and pull them out in the direction shown by the arrow ( ). Then remove the accelerator pedal pad (2).

CAUTION:
Never disengage the part (the link) other than pins.
5. Remove accelerator pedal stopper cover.
6. Pull up the floor carpet.
7. Remove mounting nuts of accelerator pedal bracket.
8. Remove accelerator pedal bracket and lever assembly.

CAUTION:
- Never disassemble accelerator lever. Never remove accelerator pedal position sensor from accelerator lever.
- Avoid impact from dropping etc. during handling.
- Be careful to keep accelerator lever away from water.

INSTALLATION
Install in the reverse order of removal.

INSPECTION AFTER INSTALLATION
- Check accelerator pedal moves smoothly within the whole operation range when it is fully depressed and released.
- Check accelerator pedal securely returns to the fully released position.
- For the electrical inspection of accelerator pedal position sensor, refer to the following:
- VQ35HR
P2122, P2127, and P2138.
- VK45DE
P2122, P2127, and P2138.

CAUTION:
When harness connector of accelerator pedal position sensor is disconnected, perform "Accelerator
Pedal Released Position Learning". Description Special Repair Requirement Description Special Repair Requirement Description Special Repair Requirement, "ACCELERATOR PEDAL RELEASED POSITION

(VK45DE).