Check Door Request Switch

INTELLIGENT KEY SYSTEM


Check Door Request Switch

1.CHECK DOOR REQUEST SWITCH
With CONSULT-III
Check door request switch ("DR REQ SW" or "AS REQ SW") in "DATA MONITOR" mode.





Without CONSULT-III
1. Turn ignition switch OFF.
2. Check voltage between Intelligent Key unit harness connector and ground.










OK or NG
OK - Door request switch is OK.
NG - GO TO 2.
2.CHECK DOOR REQUEST SWITCH CIRCUIT
1. Disconnect Intelligent Key unit and front outside handle connector.
2. Check continuity between Intelligent Key unit connector and front outside handle connector.










3. Check continuity between Intelligent Key unit connector and ground.





OK or NG
OK - GO TO 3.
NG - Repair or replace harness between Intelligent Key unit and front outside handle.
3.CHECK DOOR REQUEST SWITCH OPERATION
Check front outside handle.










OK or NG
OK - GO TO 4.
NG - Replace malfunction front outside handle.
4.CHECK DOOR REQUEST SWITCH GROUND CIRCUIT
Check continuity between front outside handle connector and ground.










OK or NG
OK - GO TO 5.
NG - Repair or replace front outside handle ground circuit.
5.CHECK INTELLIGENT KEY UNIT OUTPUT SIGNAL
1. Connect Intelligent Key unit connector.
2. Check voltage between Intelligent Key unit connector and ground.










OK or NG
OK - Check the condition of harness and connector.
NG - Replace Intelligent Key unit.