Precaution For BSW/BSI System Service

PRECAUTIONS

Precaution for BSW/BSI System Service


CAUTION:
- To prevent the possibility of accident, be careful of traffic conditions and safety around the vehicle when performing road test.
- To prevent the possibility of accident, never use the BSI system when driving with free rollers or a chassis dynamometer.
- To prevent the possibility of accident, never perform the active test while driving.
- To prevent malfunction, never disassemble and remodel the lane camera unit.
- Never change BSW initial state ON -> OFF without the consent of the customer.
- Do not use the lane camera unit that is removed from the vehicle.

TO KEEP THE BSW/BSI SYSTEM OPERATING PROPERLY, BE SURE TO OBSERVE THE FOLLOWING ITEMS:

Lane Camera Unit Maintenance
The lane camera unit for the LDW/LDP system is located above the inside mirror. To keep the proper operation of the LDW/LDP systems and prevent a system malfunction, be sure to observe the following:
- Always keep the windshield clean.
- Do not attach a sticker (including transparent material) or install an accessory near the camera unit.
- Do not place reflective materials, such as white paper or a mirror, on the instrument panel. The reflection of sunlight may adversely affect the camera unit capability of detecting the lane markers.
- Do not strike or damage the areas around the camera unit.
- Do not touch the camera lens or remove the screw located on the camera unit.
System Maintenance
The two side radar for the BSW and BSI systems are located near the rear bumper.
- Always keep the area near the side radar clean.
- Do not attach stickers (including transparent material), install accessories or apply additional paint near the side radar.
- Do not strike or damage the area around the side radar.