Special Repair Requirement

ADDITIONAL SERVICE WHEN REPLACING TRANSMISSION ASSEMBLY

Special Repair Requirement


1. PREPARATION BEFORE CALIBRATION PROCEDURE

1.Park the vehicle on a flat road.
2.Adjust pressure in all tires to the specified value. [1][2]Specifications.
- GO TO 2.

2. PERFORM CALIBRATION

With CONSULT
1.Turn ignition switch ON.

CAUTION:
Never start the engine.
2.Select "G SENSOR CALIBRATION" in "Work Support" in "TRANSMISSION".
3.Touch "START".

CAUTION:
Never give any motion to the vehicle during the calibration.
Is "COMPLETED" displayed?
YES- GO TO 3.
NO- Perform the calibration again.

3. CHECK DTC

With CONSULT
1.Turn ignition switch OFF and wait for 10 seconds.
2.Turn ignition switch ON.
3.Select "Self Diagnostic Results" in "ABS".
Is "C1145" or "C1146" detected?
YES- Testing and Inspection.
NO- Calibration end.