Removal and Installation

AUTOMATIC DRIVE POSITIONER CONTROL UNIT

Removal and Installation


REMOVAL


CAUTION:
When removing and installing, use shop cloths to protect parts from damage.
1.Remove the battery negative terminal.





2.Remove the instrument driver lower panel. Refer to "A/T MODELS : Removal and Installation" Removal and Installation A/T Models.
3.Remove the screws (A).
4.Remove automatic drive positioner control unit (1).

INSTALLATION

Install in the reverse order of removal.

CAUTION:
Be sure to clump the harness to the right place.
NOTE:
After installing the driver seat, perform additional service when removing battery negative terminal. Refer to
"ADDITIONAL SERVICE WHEN REPLACING CONTROL UNIT : Special Repair Requirement" Special Repair Requirement.