Driver/Vehicle Information Display: Service and Repair
INSTRUMENT PACK LCD MODULERENEW
Disconnect the battery.
Remove driver's side dash liner securing screws, release securing clip, and remove liner.
Release steering column clamp, fully extend steering wheel, and re-tighten the clamp.
Remove Instrument Pack assembly securing screws. Disconnect block connectors from rear of pack.
Displace and remove Instrument Pack assembly.
Remove Instrument Pack cowl-housing screws and cowl-housing. Place pack face-down on bench, ensuring cowl/lens is protected with a suitable cloth or similar.
NOTE: To minimize risk of contamination and damage, repairs to Instrument Pack should be performed in a non-static dust-free environment. Avoid touching connector pins and PCB track/components, to minimize risk of static damage.
Remove electronics pack cover securing screws and remove the cover.
Fig 1:
Carefully release the flexible printed circuit ribbon-ends from edge-connectors, by squeezeing grips between thumb and forefinger while sliding out connector-latch (Fig.1).
Fig 2:
Release electronics pack retaining clips and pivot pack upwards (Fig. 2)
Displace and remove electronics pack from instrument pack by lifting off from hinges.
Displace and remove 6 warning bulbs, 2 both sides located adjacent to LCD module, and the 2 bulbs located in module itself (bayonet fitting, twist 1/8th turn anti- clockwise to release).
Fig 3:
Disconnect the flexible printed circuit to LCD multi-plug. Remove LCD unit securing screws and unit (Fig.3).
Fit new LCD unit into position, fit and tighten LCD module securing screws.
Re-fit the warning bulbs into the empty sockets.
Re-connect the flexible printed circuit multi-plug to the LCD unit.
Carefully fit the electronics pack over flexible printed circuit connections and locate onto hinges.
Pivot pack downwards and fit into securing clips.
Fit flexible printed circuit to edge-connectors, by positioning holes in flexible printed circuit membrane over connector-latch locating pips and sliding latch to the fully closed position.
Align and fit back cover to the electronics pack. Fit and tighten the securing screws.
Fit the cowl-housing to the pack.
Fit and tighten the cowl-housing securing screws.
Fit the instrument pack assembly into dashboard position, re-connect the block connectors.
Align assembly, fit and tighten the securing screws
Return steering wheel to original position
Refit the dash liner.
Reconnect the battery.
NOTE: On re-connection of the battery, it is important that the ignition is cycled and the bulb check is completed. The odometer reading will then be restored to the correct value.