Engine Control Module: Service and Repair

Removal
1. Disconnect battery ground cable. Refer to 'Battery, Service and Repair.' Service and Repair






2. Remove ECM housing cover.
3. RHD only: Remove security bracket securing screws.

Remove bracket

4. Disconnect electrical connectors.







5. Lift ECM from housing.
6. RHD only: Remove security bracket securing screws.
Remove brackets.

Installation


1. NOTE: A replacement ECM may only be obtained from an authorized Jaguar dealer and MUST be ordered against the VIN.


NOTE: Check condition of housing seals and replace as necessary.


Installation is a reversal of the removal procedure.

2. Synchronize ECM, KTM and BPM using PDU.
3. Complete engine set-up using JDS/PDU.