Sunroof / Moonroof: Adjustments

ADJUSTMENT OF SLIDING ROOF PANEL PROFILE

Removal
1. Remove sliding roof trim panel for access. Service and Repair
2. Turn ignition switch to position II.
3. Fully close sliding roof.
4. Turn ignition switch to position O and remove key.







5. Slacken sliding panel to frame securing bolts.
6. Ensuring that seal is not compressed, press sliding panel forward.







7. Align sliding panel with roof contour.
- Adjust front edge of panel to align with roof contour within -1 +0 mm.
- Adjust rear edge of panel to align with roof contour within -0 +1 mm.







8. Ensuring that roof panel setting is not disturbed, tighten the outer four sliding panel to frame securing bolts.
9. Insert key and turn ignition switch to II.
10. Check for satisfactory fit and operation by opening and closing roof panel and re-adjust as necessary.
11. Turn ignition switch to position O.
12. Tighten all sliding panel to frame securing screws.
13. Fit trim panel. Service and Repair