Front Lamps

Front Lamps

Locations:

Headlamp assembly
Each headlamp assembly consists of two headlamp units. The dipped beam lamp unit is located outboard and the main beam lamp unit located inboard also carries the front parking (side) lamp. Access for bulb replacement is from the engine compartment.

Direction Indicator and Side Marker Lamps
Each front direction indicator and side marker lamp is retained in the bumper cover by a lug at one end and a spring clip at the other end. The side marker lamps are not electrically connected for certain markets.

The side repeater lamps are secured by spring clips on the lower edge of the lamp unit. In certain markets Jaguar leaper badges are substituted for side repeater lamps.

Fog Lamps
The fog lamps are located in recesses in the front bumper and secured by three screws. The lamps which are not interchangeable left to right, are accessed from the rear of the bumper.

Operation
All lamps are controlled by the BPM which provides an appropriate output in response to an input received when a selected switch is operated.

All lamps receive an input direct from the BPM with the exception of the main beam, dip beam and front fog lamps which receive an input from the BPM via the respective relays and fuses.

Fault analysis must be undertaken using the PDU. Refer to Diagnosis and Testing. Testing and Inspection

Consult the relevant Electrical Diagram for details of circuit operation. Electrical Diagrams