Sunroof / Moonroof: Adjustments

Roof Opening Panel Alignment

1. NOTE: Left-hand shown, right-hand similar.

Detach the sight shield at the front of the roof and swing inwards towards the rear of vehicle.







2. CAUTION:
- Make sure the air deflector is only detached from the roof opening panel using the 20 mm (0.78 inches) area at the end of the air deflector as defined in step 1 of the illustration and text below. Failure to follow this instruction will result in damage to the component.
- Do not pull on the air deflector rubber pleat. Failure to follow this instruction will result in damage to the component.

NOTE: Right-hand shown, left-hand similar.

Detach the air deflector.
- Detach the rear of the air deflector.
- Detach the air deflector upper retainer.
- Swing the front of the air deflector inwards towards the rear of the vehicle.







3. NOTE: Left-hand shown, right-hand similar.

Loosen the roof opening panel glass retaining screws.







4. Adjust the front edge of the roof opening panel glass to between flush and 1 mm (0.04 in) low.







5. Adjust the rear glass edge to between flush and 1 mm (0.04 in) low.







6. NOTE: Left-hand shown, right-hand similar.

Tighten to 4 Nm.







7. NOTE: Right-hand shown, left-hand similar.

Reposition the air deflector to the roof opening panel runner.







8. NOTE: Right-hand shown, left-hand similar.

Install the air deflector.
- Make sure the air deflector is fully seated to the rear retaining clip.
- Attach the air deflector upper retainer.







9. NOTE: Left-hand shown, right-hand similar.

Install the sight shields.