Vehicle Speed Interface Module: Service and Repair

Vehicle Speed Interface Module

Removal
1. Remove battery cover and disconnect ground cable from battery terminal.







2. Remove passenger side false bulkhead cover.
- Pull forward then lift cover inner edge to release tangs.
- Pull cover inwards to release outer tabs and lift clear.







3. Remove engine compartment cool box cover screws.







4. Remove module from coolbox lid.
- Carefully lift and invert lid for access.
- Disconnect module harness connector.
- Release module from velcro pad.

Installation







1. Install Module.
- Connect harness connector to module.
- Position module on underside of coolbox lid and firmly seat module on velcro pad.







2. Position lid on coolbox and install screws.
3. Install passenger side false bulkhead cover.
4. Connect ground cable to battery terminal and install battery cover.