P0831

G : P0831, P0832. CLUTCH CANCEL SWITCH, HIGH/LOW VOLTAGE

G1 : CHECK THE POWER SUPPLY CIRCUIT TO THE CLUTCH CANCEL SWITCH

1. Disconnect the clutch cancel switch electrical connector, PA4.
2. Turn the ignition switch to the ON position.
3. Measure the voltage between PA4, pin 1 (RW) and GROUND.

Is the voltage greater than 10 volts?
Yes
Goto G2

No
REPAIR the circuit between the clutch cancel switch electrical connector, PA4, pin 1 (RW) and the ignition switch. For additional information, refer to wiring diagrams. CLEAR the DTC. TEST the system for normal operation.
This circuit includes the ignition relay and the inertia switch

G2 : CHECK THE POWER SUPPLY CIRCUIT TO THE CLUTCH CANCEL SWITCH FOR SHORT CIRCUIT TO BATTERY

1. Disconnect the clutch cancel switch electrical connector, PA4.
2. Turn the ignition switch to the OFF position.
3. Measure the voltage between PA4, pin 1 (RW) and GROUND.

Is the voltage greater than 1 volt?
Yes
REPAIR the short circuit. For additional information, refer to wiring diagrams. CLEAR the DTC. TEST the system for normal operation.

No
Goto G3

G3 : CHECK THE SWITCH ACTION OF THE CLUTCH CANCEL SWITCH

1. Connect an ohmmeter between pins 1 and 3 of the clutch cancel switch.
2. Operate the clutch pedal up and down, while observing the resistance reading.

Does the resistance switch between open and closed circuit as the pedal is operated?
Yes
Goto G4

No
INSTALL a new clutch cancel switch. CLEAR the DTC. TEST the system for normal operation.

G4 : CHECK THE SWITCH ACTION OF THE CLUTCH CANCEL SWITCH

1. Disconnect the PCM electrical connector, EN16.
2. Reconnect the clutch cancel switch electrical connector, PA4.
3. Connect a voltmeter between PCM electrical connector EN16, pin 33 (WG) and GROUND.
4. Turn the ignition switch to the ON position.
5. Operate the clutch pedal up and down, while observing the voltage reading.

Does the voltage switch between 0 volts and battery voltage as the pedal is operated?
Yes
INSTALL a new PCM. Before replacing a PCM, contact Dealer technical support. CLEAR the DTC. TEST the system for normal operation.

No
Goto G5

G5 : CHECK THE CLUTCH CANCEL SWITCH SIGNAL WIRE FOR CONTINUITY

1. Turn the ignition switch to the OFF position.
2. Disconnect clutch cancel switch electrical connector, PA4.
3. Measure the resistance between clutch cancel switch electrical connector PA4, pin 3 (W) and PCM electrical connector EN16, pin 33 (WG).

Is the resistance less than 5 ohms?
Yes
No electrical fault in circuit. RECHECK DTCs.

No
REPAIR the circuit between clutch cancel switch electrical connector PA4, pin 3 (W) and PCM electrical connector EN16, pin 33 (WG). For additional information, refer to wiring diagrams. CLEAR the DTC. TEST the system for normal operation.