Lumbar Motor - Vehicles With: Recaro Seats

Lumbar Motor - Vehicles With: Recaro Seats (86.75.12)

Removal

1. Detach the front seat backrest cover rear lower retaining clip.







2. Detach the front seat backrest cover rear upper retaining clips.







3. Using a suitable knife, detach the front seat backrest cover from the front seat frame.







4. Remove the front seat backrest.
- Disconnect the front seat backrest heater mat electrical connector.







5. Remove the front seat tilt knob.







6. Remove the front seat tilt knob trim panel retaining screw trim cover.







7. Remove the front seat tilt knob trim panel retaining screw.







8. Remove the front seat tilt knob trim panel.
- Release the front seat tilt knob trim panel retaining tang from inside the front seat backrest frame.







9. Detach the front seat backrest trim panel lower retaining clips.







10. Remove the front seat backrest trim panel.







11. Disconnect the lumbar motor electrical connector.







12. Remove and discard the lumbar motor wiring harness tie strap.







13. Remove the lumbar motor retaining screws.
- Remove the lumbar motor retaining screw clamps.







14. Remove the lumbar motor.







Installation

1. NOTE: Install a new tie strap.

To install, reverse the removal procedure.