Rear Lamps

Rear Lamps

Locations:

License Plate Lamps
Each license plate bulb is accessible after removing the relevant lens. The license plate lamps can be accessed following removal of the trunk lid liner and upper trim finisher.

Rear Lamp Assembly
Each rear lamp assembly incorporates a stop/tail lamp, a fog lamp, a reversing lamp and a direction indicator lamp. Access for bulb replacement is from the trunk.

Side Markers
Each side marker is retained in the bumper cover by a lug on one end of the unit and a spring clip at the other end. The unit is not electrically connected for all markets.

High Mounted Stop Lamp
The high mounted stop lamp (HMSL) is secured to studs on the center lower edge of the backlight and provides illumination using five bulbs.

Operation
All lamps are controlled by the BPM which provides an appropriate output in response to an input received when a selected switch is operated.

All lamps receive an input direct from the BPM with the exception of the main beam, dip beam and front fog lamps which receive an input from the BPM via the respective relays and fuses. Fault analysis must be undertaken using the PDU. Testing and Inspection

Consult the relevant Electrical Diagram for details of circuit operation. Diagrams