Control Module: Service and Repair

Transmission Control Module (TCM)

Removal





1. Disconnect battery ground cable.
Remove the battery cover.





2. Remove the trim panel from the engine compartment, passenger side.
Remove the left hand side enclosure panel.
If necessary, remove the center trim panel.





3. Release the fixings and remove the cover from the ECM/TCM housing.





4. Disconnect the TCM harness multiplug EM007.
5. Lift the TCM from its housing.

Installation

1. NOTE: A replacement TCM may only be obtained from an authorized Jaguar dealer and MUST be ordered against the VIN.

Fitting a new TCM is the reverse of the removal procedure.
At this point ensure that the ECM is correctly located and pushed fully rearward against the housing.
2. Connect the battery and fit the battery cover..
Reset the radio and the clock.