Symptom Related Diagnostic Procedures
Pinpoint TestsA: J-GATE SYSTEM CIRCUIT CHECKS
A1: CHECK FOR IGNITION FEED TO THE J-GATE
1. Disconnect the J-gate assembly electrical connector CA245.
2. Turn the ignition to the 'ON' position.
3. Measure the voltage at CA245 Pin 1 (GO).
^ Is the voltage greater than 10 Volts?
-> Yes Go to [A2]
-> No Repair the electrical circuit between the J-gate assembly electrical connector CA245 Pin 1 (GO) and the rear power distribution box FUSE 3. Clear the DTC. TEST the system for normal operation.
NOTE: This circuit incorporates the ignition switch and the primary junction box.
A2: CHECK THE GROUND SUPPLY TO THE J-GATE
1. Measure the resistance between the J-gate assembly electrical connector CA245 Pin 2 (B) and GROUND.
^ *Is the resistance less than 5.0 Ohms?
-> Yes Go to [A3]
-> No Repair the circuit between the J-gate assembly electrical connector CA245 Pin 2 (B) and GROUND. Clear the DTC. TEST the system for normal operation.
A3: CHECK FOR J-GATE ILLUMINATION FEED
1. Turn the ignition to the 'ON' position.
2. Measure the voltage at CA245 Pin 3 (UY).
Is the voltage greater than 10 Volts?
-> Yes Go to [A4]
-> No Repair the electrical circuit between the J-gate assembly electrical connector CA245 Pin 3 (UY) and the front electronics module electrical connector. Clear the DTC. TEST the system for normal operation.
A4: CHECK FOR KEY INTERLOCK FEED CIRCUIT FOR CONTINUITY
1. Disconnect the J-gate assembly electrical connector CA245.
2. Disconnect the ignition switch electrical connector FC018.
3. 3) Measure the resistance between the J-gate assembly electrical connector CA245 Pin 4 (Y) and the ignition switch electrical connector FC018 Pin 3 (Y).
Is the resistance less than 5.0 Ohms?
-> Yes Go to [A5]
-> No Repair the electrical circuit between the J-gate assembly electrical connector CA245 Pin 4 (Y) and the ignition switch electrical connector FC01 8 Pin 3 (Y). Clear the DTC. TEST the system for normal operation.
A5: CHECK FOR KEY INTERLOCK ACTION
1. Check for continuity between Pin 3 and Pin 4 of the ignition switch lock cylinder.
As the circuit continuous?
-> Yes Install a new J-gate. Clear the DTC. TEST the system for normal operation.
-> No Install a new ignition switch lock cylinder. Clear the DTC. TEST the system for normal operation.