P0096

AD : P0096, P0097, P0098 Supercharger Intake Air Temperature Sensor

AD1 : CHECK THE SUPERCHARGER INTAKE AIR TEMPERATURE SENSOR SIGNAL WIRE FOR OPEN CIRCUIT
1. Turn the ignition switch to the OFF position.
2. Disconnect the supercharger IAT sensor electrical connector PI43.
3. Disconnect the PCM electrical connector PI01.
4. Measure the resistance between the oil temperature sensor electrical connector PI43, pin 1 (YU) and the PCM electrical connector PI01, pin 72 (YU).

Is the resistance less than 5 ohms?

Yes
Goto AD2

No
Repair the circuit. For additional information, refer to the wiring diagrams. CLEAR the DTCs. TEST the system for normal operation.

AD2 : CHECK THE SUPERCHARGER INTAKE AIR TEMPERATURE SENSOR GROUND CIRCUIT FOR OPEN CIRCUIT
1. Measure the resistance between the oil temperature sensor electrical connector PI43, pin 2 (BG) and GROUND.

Is the resistance less than 5 ohms?

Yes
Goto AD3

No
Repair the circuit. For additional information, refer to the wiring diagrams. CLEAR the DTCs. TEST the system for normal operation.

AD3 : CHECK THE SUPERCHARGER INTAKE AIR TEMPERATURE SENSOR GROUND CIRCUIT FOR SHORT TO BATTERY
1. Connect PCM electrical connector, PI01
2. Turn the ignition switch to the RUN position.
3. Measure the voltage between the oil temperature sensor electrical connector PI43, pin 2 (BG) and GROUND.

Is a voltage present?

Yes
Repair the short circuit. For additional information, refer to the wiring diagrams. CLEAR the DTCs. TEST the system for normal operation.

No
Goto AD4

AD4 : CHECK THE SUPERCHARGER INTAKE AIR TEMPERATURE SENSOR CIRCUIT FOR A SHORT TO GROUND
1. Measure the resistance between the oil temperature sensor electrical connector PI43, pin 1 (YU) and GROUND.

Is the resistance less than 10,000 ohms?

Yes
Repair the short to GROUND. For additional information, refer to the wiring diagrams. CLEAR the DTCs. TEST the system for normal operation.

No
Goto AD5

AD5 : CHECK THE SUPERCHARGER INTAKE AIR TEMPERATURE SENSOR CIRCUIT FOR A SHORT TO BATTERY POSITIVE
1. Connect PCM electrical connector, PI01
2. Turn the ignition switch to the ON position.
3. Measure the voltage between the oil temperature sensor electrical connector PI43, pin 1 (YU) and GROUND.

Is the voltage greater than 10 volts?

Yes
Repair the short to battery positive. For additional information, refer to the wiring diagrams. CLEAR the DTCs. TEST the system for normal operation.

No
Install a new oil temperature sensor. CLEAR DTCs. TEST the system for normal operation. If the DTC is repeated, INSTALL a new PCM.