C1175
DTC C1175; LEFT-HAND REAR WHEEL SPEED SENSOR (WSS) CIRCUIT FAILUREG92304t33: CHECK THE LEFT-HAND REAR WSS SENSOR CIRCUIT FOR HIGH RESISTANCE
1. Make sure the ignition switch is in the OFF position.
2. Disconnect the ABS/DSC module electrical connector, JB45/JB185.
3. Measure the resistance between CA55, pin 02 (WU) and JB45/JB185, pin 14 (WU).
^ Is the resistance greater than 5 ohms?
> Yes REPAIR the high resistance circuit. CLEAR the DTC, test the system for normal operation.
> No
G92304t34: CHECK THE LEFT-HAND REAR WSS SENSOR CIRCUIT FOR SHORT CIRCUIT TO BATTERY
1. Measure the voltage between CA55, pin 02 (WU) and GROUND.
^ Is the voltage greater than 3 volts?
> Yes REPAIR the short circuit. CLEAR the DTC, test the system for normal operation.
> No
G92304t35: CHECK THE LEFT-HAND REAR WSS SENSOR CIRCUIT FOR SHORT CIRCUIT TO GROUND
1. Measure the resistance between CA55, pin 02 (WU) and GROUND.
^ Is the resistance less than 10,000 ohms?
> Yes REPAIR the short circuit. CLEAR the DTC, test the system for normal operation.
> No
G92304t36: CHECK THE LEFT-HAND REAR WSS POWER CIRCUIT FOR HIGH RESISTANCE
1. Disconnect the wheel speed sensor.
2. Measure the resistance between CA55, pin 01 (GB) and JB45/JB185, pin 13 (GB).
^ Is the resistance greater than 5 ohms?
> Yes REPAIR the high resistance circuit. CLEAR the DTC, test the system for normal operation.
> No
G92304t37: CHECK THE LEFT-HAND REAR WSS POWER CIRCUIT FOR SHORT CIRCUIT TO BATTERY
1. Measure the voltage between CA55, pin 01 (GB) and GROUND.
^ Is the voltage greater than 3 volts?
> Yes REPAIR the short circuit. CLEAR the DTC, test the system for normal operation.
> No
G92304t38: CHECK THE LEFT-HAND REAR WSS POWER CIRCUIT FOR SHORT CIRCUIT TO GROUND
1. Measure the resistance between CA55, pin 01 (GB) and GROUND.
^ Is the resistance less than 10,000 ohms?
> Yes REPAIR the short circuit. CLEAR the DTC, test the system for normal operation.
> No INSTALL a new WSS, CLEAR the DTC, test the system for normal operation. If the DTC is repeated, please check part is not on any form of prior authorization before replacement.