P0010

R : P0010. VVT RIGHT-HAND BANK

G92429t111 : CHECK THE GROUND CIRCUIT TO THE RIGHT-HAND BANK WT SOLENOID
1. Disconnect the WT solenoid electrical connector EN61.
2. Measure the resistance between the WT solenoid electrical connector EN61 pin 2 (BG) and GROUND.

- Is the resistance less than 5 ohms?

-> Yes

-> No
REPAIR the circuit between WT solenoid electrical connector EN61 pin 2 (BG) and GROUND. CLEAR the DTC. TEST the system for normal operation.

G92429t112 : CHECK CONTINUITY OF THE RIGHT-HAND BANK WT SOLENOID SIGNAL WIRE
1. Measure the resistance between WT solenoid electrical connector EN61 pin 1 (RW) and ECM electrical connector EN16 pin 109 (RW).

- Is the resistance less than 5 ohms?

-> Yes

-> No
REPAIR the circuit between WT solenoid electrical connector EN61 pin 1 (RW) and ECM electrical connector EN16 pin 109 (RW). CLEAR the DTC. TEST the system for normal operation.

G92429t84 : CHECK FOR SHORT TO GROUND AT THE RIGHT-HAND BANK WT SOLENOID SIGNAL WIRE
1. Disconnect the ECM electrical connector EN16.
2. Measure the resistance between EN61 pin 1 (RW) and GROUND.

- Is the resistance less than 10,000 ohms?

-> Yes
REPAIR the short to GROUND. CLEAR the DTC. TEST the system for normal operation.

-> No

G92429t85 : CHECK FOR SHORT TO BATTERY AT THE RIGHT-HAND BANK WT SOLENOID SIGNAL WIRE
1. TURN the ignition switch to the ON position.
2. Check for a voltage at EN61 pin 1 (RW).

- Is the voltage greater than 1 volt?

-> Yes
REPAIR the short circuit. CLEAR the DTC. TEST the system for normal operation.

-> No
INSTALL a new right-hand bank VVT solenoid. CLEAR the DTC. TEST the system for normal operation.