P0834

H : P0834. clutch pedal safety switch, HIGH/LOW VOLTAGE

G92531t12 : CHECK THE POWER SUPPLY CIRCUIT TO THE CLUTCH PEDAL SAFETY SWITCH
1. Disconnect the clutch pedal safety switch electrical connector, PAS.
2. Turn the ignition switch to the ON position.
3. Measure the voltage between PAS, pin 1 (RW) and GROUND.

- Is the voltage greater than 10 volts?

-> Yes

-> No
REPAIR the circuit between the clutch pedal safety switch electrical connector, PAS, pin 1 (RW) and the ignition switch. CLEAR the DTC. TEST the system for normal operation.

G92531t21 : CHECK THE POWER SUPPLY CIRCUIT TO THE CLUTCH PEDAL SAFETY SWITCH FOR SHORT CIRCUIT TO BATTERY
1. Disconnect the clutch pedal safety switch electrical connector, PAS.
2. Turn the ignition switch to the OFF position.
3. Measure the voltage between PAS, pin 1 (RW) and GROUND.

- Is the voltage greater than 1 volt?

-> Yes
REPAIR the short circuit. CLEAR the DTC. TEST the system for normal operation.

-> No

G92531t13 : CHECK THE SWITCH ACTION OF THE CLUTCH PEDAL SAFETY SWITCH
1. Connect an ohmmeter between pins 1 and 2 of the clutch pedal safety switch.
2. Operate the clutch pedal up and down, while observing the resistance reading.

- Does the resistance switch between open and closed circuit as the pedal is operated?

-> Yes

-> No
INSTALL a new clutch pedal safety switch. CLEAR the DTC. TEST the system for normal operation.

G92531t14 : CHECK THE SWITCH ACTION OF THE CLUTCH PEDAL SAFETY SWITCH
1. Disconnect the ECM electrical connector, EN16.
2. Reconnect the clutch pedal safety switch electrical connector, PAS.
3. Connect a voltmeter between ECM electrical connector EN16, pin 31 (B) and GROUND.
4. Turn the ignition switch to the ON position.
5. Operate the clutch pedal up and down, while observing the voltage reading.

- Does the voltage switch between 0 volts and battery voltage as the pedal is operated?

-> Yes
INSTALL a new ECM. Before replacing a ECM, contact Dealer technical support. CLEAR the DTC. TEST the system for normal operation.

-> No

G92531t15 : CHECK THE CLUTCH PEDAL SAFETY SWITCH SIGNAL WIRE FOR CONTINUITY
1. Turn the ignition switch to the OFF position.
2. Disconnect the clutch pedal safety switch electrical connector, PAS.
3. Measure the resistance between clutch pedal safety switch electrical connector PAS, pin 2 (W) and ECM electrical connector EN16, pin 31 (B).

- Is the resistance less than 5 ohms?

-> Yes
No electrical fault in circuit. RECHECK DTCs.

-> No
REPAIR the circuit between clutch pedal safety switch electrical connector PAS, pin 2 (W) and ECM electrical connector EN16, pin 31 (B). CLEAR the DTC. TEST the system for normal operation.