C1235

PINPOINT TEST G92304p3: DTC C1165, C1235; RIGHT-HAND REAR WHEEL SPEED SENSOR (WSS) CIRCUIT FAILURE

G92304t26: CHECK THE RIGHT-HAND REAR WSS SENSOR CIRCUIT FOR HIGH RESISTANCE

1. Make sure the ignition switch is in the OFF position.
2. Disconnect the ABS/DSC module electrical connector, JB45/JB185.
3. Disconnect the wheel speed sensor electrical connector, CA60.
4. Measure the resistance between CA60, pin 02 (WG) and JB45/JB185, pin 31 (WG).
^ Is the resistance greater than 5 ohms?

-> Yes
REPAIR the high resistance circuit. For additional information, refer to the wiring diagrams. CLEAR the DTC, test the system for normal operation.

-> No
GO to Pinpoint Test G92304t27.

G92304t27: CHECK THE RIGHT-HAND REAR WSS SENSOR CIRCUIT FOR SHORT CIRCUIT TO BATTERY

1. Measure the voltage between CA60, pin 02 (WG) and GROUND.
^ Is the voltage greater than 3 volts?

-> Yes
REPAIR the short circuit. For additional information, refer to the wiring diagrams. CLEAR the DTC, test the system for normal operation.

-> No
GO to Pinpoint Test G92304t28.

G92304t28: CHECK THE RIGHT-HAND REAR WSS SENSOR CIRCUIT FOR SHORT CIRCUIT TO GROUND

1. Measure the resistance between CA60, pin 02 (WG) and GROUND.
^ Is the resistance less than 10,000 ohms?

-> Yes
REPAIR the short circuit. For additional information, refer to the wiring diagrams. CLEAR the DTC, test the system for normal operation.

-> No
GO to Pinpoint Test G92304t29.

G92304t29: CHECK THE RIGHT-HAND REAR WSS POWER CIRCUIT FOR HIGH RESISTANCE

1. Disconnect the wheel speed sensor.
2. Measure the resistance between CA60, pin 01 (NG) and JB45/JB185, pin 30 (NG).
^ Is the resistance greater than 5 ohms?

-> Yes
REPAIR the high resistance circuit. For additional information, refer to the wiring diagrams. CLEAR the DTC, test the system for normal operation.

-> No
GO to Pinpoint Test G92304t3O.

G92304t30: CHECK THE RIGHT-HAND REAR WSS POWER CIRCUIT FOR SHORT CIRCUIT TO BATTERY

1. Measure the voltage between CA60, pin 01 (NG) and GROUND.
^ Is the voltage greater than 3 volts?

-> Yes
REPAIR the short circuit. For additional information, refer to the wiring diagrams. CLEAR the DTC, test the system for normal operation.

-> No
GO to Pinpoint Test G92304t31.

G92304t31 : CHECK THE RIGHT-HAND REAR WSS POWER CIRCUIT FOR SHORT CIRCUIT TO GROUND

1. Measure the resistance between CA60, pin 01 (NG) and GROUND.
^ Is the resistance less than 10,000 ohms?

-> Yes
REPAIR the short circuit. For additional information, refer to the wiring diagrams. CLEAR the DTC, test the system for normal operation.

-> No
INSTALL a new WSS. CLEAR the DTC, test the system for normal operation. If the DTC is repeated, please check part is not on any form of prior authorization before replacement.