Parking Brake Module - Vehicles With: Convertible Top
Parking Brake Module - Vehicles With: Convertible TopRemoval
1. Remove the cover and disconnect the battery ground cable.
2. Make the SRS system safe.
3. Remove the LH roll over protection unit.
4. Remove the rear seat RH backrest retaining bracket.
> Remove the 2 nuts and 2 bolts.
5. Remove the RH roll over protection unit.
> Disconnect the electrical connector.
> Remove the 4 Torx bolts.
6. Release the auxiliary junction box mounting bracket.
> Remove the 3 nuts.
7. Remove the parking brake module.
> Remove the 3 nuts.
> Disconnect the 2 electrical connectors.
Installation
1. Install the parking brake module.
> Tighten the nuts to 4 Nm (3 lb.ft).
> Connect the electrical connectors.
2. Secure the auxiliary junction box mounting bracket.
> Tighten the nuts to 10 Nm (7 lb.ft).
3. Install the rear seat RH backrest retaining bracket.
> Tighten the nuts and bolts to 10 Nm (7 lb.ft).
4. Install the RH roll over protection unit.
> Tighten the Torx bolts to 25 Nm (18 lb.ft).
> Connect the electrical connector.
5. Install the LH roll over protection unit.
6. Connect the battery ground cable and install the cover.
7. Connect WDS to the vehicle and configure a new module.