Vehicle Speed Sensor/Transducer - Cruise Control: Service and Repair

Speed Control Sensor

Removal
1. Connect WDS to the vehicle and up-load the relevant data.
2. Raise and support the vehicle.

WARNING: Do not work on or under a vehicle supported only by a jack. Always support the vehicle on safety stands.

3. Remove the front bumper cover.
4. Remove the speed control sensor.
- Remove the 2 bolts.
- Remove the nut.
- Disconnect the electrical connector.







Installation
1. Install the speed control sensor.
- Tighten the bolts to 5 Nm (4lb.ft).
- Install the speed sensor level adjustment lock nut and tighten to 5 Nm (4lb.ft).
- Connect the electrical connector.
2. Check and adjust the speed sensor leveling.
3. With assistance, install the front bumper cover.
4. Using WDS download the data previously up-loaded.