P0832

F : P0831, P0832. Clutch Cancel Switch, High/Low Voltage.

F1 : CHECK THE POWER SUPPLY CIRCUIT TO THE CLUTCH CANCEL SWITCH.
1. Disconnect the clutch cancel switch electrical connector, CA285.
2. Turn the ignition switch to the ON position.
3. Measure the voltage between CA285, pin 1 (NR) and GROUND.

Is the voltage greater than 10 volts?

Yes
Goto F2

No
REPAIR the circuit between the clutch cancel switch electrical connector, CA285, pin 1 (NR) and the ignition switch.
This circuit includes the ignition relay and the inertia switch.
For additional information, refer to wiring diagrams. CLEAR the DTC. TEST the system for normal operation.

F2 : CHECK THE POWER SUPPLY CIRCUIT TO THE CLUTCH CANCEL SWITCH FOR SHORT CIRCUIT TO BATTERY
1. Disconnect the clutch cancel switch electrical connector, CA285.
2. Turn the ignition switch to the OFF position.
3. Measure the voltage between CA285, pin 1 (NR) and GROUND.

Is the voltage greater than 1 volt?

Yes
Repair the short circuit. For additional information, refer to wiring diagrams. CLEAR the DTC. TEST the system for normal operation.

No
Goto F3

F3 : CHECK THE SWITCH ACTION OF THE CLUTCH CANCEL SWITCH.
1. Connect an ohmmeter between pins 1 and 2 of the clutch cancel switch.
2. Operate the clutch pedal up and down, while observing the resistance reading.

Does the resistance switch between open and closed circuit as the pedal is operated?

Yes
Goto F4

No
INSTALL a new clutch cancel switch. CLEAR the DTC. TEST the system for normal operation.

F4 : CHECK THE SWITCH ACTION OF THE CLUTCH CANCEL SWITCH.
1. Disconnect the PCM electrical connector, PI01.
2. Reconnect the clutch cancel switch electrical connector, CA285.
3. Connect a voltmeter between PCM electrical connector PI01, pin 33 (WG) and GROUND.
4. Turn the ignition switch to the ON position.
5. Operate the clutch pedal up and down, while observing the voltage reading.

Does the voltage switch between 0 volts and battery voltage as the pedal is operated?

Yes
INSTALL a new PCM. CLEAR the DTC. TEST the system for normal operation.

No
Goto F5

F5 : CHECK THE CLUTCH CANCEL SWITCH SIGNAL WIRE FOR CONTINUITY.
1. Turn the ignition switch to the OFF position.
2. Disconnect clutch cancel switch electrical connector, CA285.
3. Measure the resistance between clutch cancel switch electrical connector CA285, pin 3 (W) and PCM electrical connector PI01, pin 33 (WG).

Is the resistance less than 5 ohms?

Yes
No electrical fault in circuit. Recheck DTCs.

No
REPAIR the circuit between clutch cancel switch electrical connector CA285, pin 3 (W) and PCM electrical connector PI01, pin 33 (WG). For additional information, refer to wiring diagrams. CLEAR the DTC. TEST the system for normal operation.