P1410

AE : P1410 Supercharger Air Cleaner Additional Air Inlet Actuator

AE1 : CHECK THE FUSE 37 IN THE FPDB
1. CHECK fuse 37 in the FPDB.

Is the fuse ok?

Yes
Goto AE3

No
Goto AE2

AE2 : CHECK FOR A SHORT TO GROUND BETWEEN THE FPDB AND THE SUPERCHARGER AIR CLEANER ADDITIONAL AIR INLET ACTUATOR
1. DISCONNECT the supercharger air cleaner additional air inlet actuator electrical connector FH010.
2. MEASURE the resistance between supercharger air cleaner additional air inlet actuator electrical connector FH010 pin 1 (GU) and ground.

Is the resistance less than 10,000 ohms?

Yes
Repair the circuit between supercharger air cleaner additional air inlet actuator electrical connector FH010 pin 1 (GU) and the FPDB. Install a new fuse. CLEAR the DTC. TEST the system for normal operation

No
Install a new fuse. CLEAR the DTC. TEST the system for normal operation.

AE3 : CHECK FOR BATTERY VOLTAGE AT THE SUPERCHARGER AIR CLEANER ADDITIONAL AIR INLET ACTUATOR
1. CHECK the voltage at supercharger air cleaner additional air inlet actuator electrical connector FH010 pin 1 (GU).

Is the voltage less than 10 volts.

Yes
Repair the circuit. For additional information, refer to wiring diagrams. CLEAR the DTC. TEST the system for normal operation.
This circuit includes the power distribution fuse box and the EMS relay.

No
Goto AE4

AE4 : CHECK THE CONTINUITY BETWEEN THE SUPERCHARGER AIR CLEANER ADDITIONAL AIR INLET ACTUATOR AND PCM
1. DISCONNECT the PCM electrical connector PI01.
2. MEASURE the resistance between the supercharger air cleaner additional air inlet actuator electrical connector FH010 pin 2 (U) and PCM electrical connector PI01 pin 14 (U).

Is the resistance less than 5 ohms?

Yes
Repair the circuit. For additional information, refer to wiring diagrams. CLEAR the DTC. TEST the system for normal operation.

No
Install a new supercharger air cleaner additional air inlet actuator. CLEAR the DTC. TEST the system for normal operation. If the DTC is repeated, INSTALL a new PCM.