Programming and Relearning

Motor Synchronization (76.82.48)

1. NOTE: If a new component is installed.

Press and hold the front of the switch, hold down untill the roof opening panel has completed a full open/close cycle.
- The roof opening panel is now synchronized.

2. NOTE: If the removed component is re-installed.

Press and hold the the front of the switch, the roof opening panel will move to the tilt position. Release the switch then press and hold the front of the switch, then the roof opening panel will move slightly more after 20 seconds.
- The roof opening panel is now un-synchronized.

3. NOTE: If the removed component is re-installed.

Press and hold the front of the switch, hold down untill the roof opening panel has completed a full open/close cycle.
- This action must be done within 2-3 seconds of the last action.
- The roof opening panel is now synchronized.