Sunroof / Moonroof: Adjustments

Roof Opening Panel Alignment

1. NOTE: Left-hand shown, right-hand similar.

Detach the sight shield at the front of the roof and swing inwards towards the rear of vehicle.







2. CAUTION:
- Make sure the air deflector is only detached from the roof opening panel using the 20mm (0.78 inches) area at the end of the air deflector as defined in step 1 of the illustration and text below. Failure to follow this instruction will result in damage to the component.
- Do not pull on the air deflector rubber pleat. Failure to follow this instruction will result in damage to the component.

NOTE: Right-hand shown, left-hand similar.

Detach the air deflector.
- Detach the rear of the air deflector.
- Detach the air deflector upper retainer.
- Swing the front of the air deflector inwards towards the rear of the vehicle.







3. NOTE: Left-hand shown, right-hand similar.

Loosen the roof opening panel glass retaining screws.







4. Adjust the front edge of the roof opening panel glass to between flush and 1 mm (0.04 in) low.







5. Adjust the rear glass edge to between flush and 1 mm (0.04 in) low.







6. NOTE: Left-hand shown, right-hand similar.

Tighten to 4 Nm.







7. NOTE: Right-hand shown, left-hand similar.

Reposition the air deflector to the roof opening panel runner.







8. NOTE: Right-hand shown, left-hand similar.

Install the air deflector.
- Make sure the air deflector is fully seated to the rear retaining clip.
- Attach the air deflector upper retainer.







9. NOTE: Left-hand shown, right-hand similar.

Install the sight shields.