Connectors, Grounds and Splices

Connectors, Grounds And Splices

Connectors, grounds and splices are numbered using a five character format, for example: CA001, CA002, G03BL, FLS25. Pin numbers are designated using only significant digits, therefore CA001 pin 001 is represented as CA001/1.

Control Module Pins
B+ Battery voltage
C CAN negative
C+ CAN positive
D Data
GND Ground
GREF Sensor/signal ground **
IP Input signal
LIN Local interconnect network
MOST_RX MOST receive
MOST_TX MOST transmit
NEG Negative
OP Output signal
P Power ground
POS Positive
PWR Power
SW Switch
VBATT Battery voltage
VREF Sensor/signal supply V *

* May also indicate Reference Voltage.
** May also indicate Reference Ground or Logic Ground.

Wiring Color Codes
N Brown
B Black
W White
K Pink
G Green
R Red1
Y Yellow
O Orange
S Slate
L Light
U Blue
P Purple
OPT Fiber Optic
SCR Screen Braid

Wire Lengths
Wire lengths are stated in millimeters and appear directly below the color code for each wire.

Twisted Wires

Twisted Wires:

The "figure-of-eight" symbol indicates that wires are twisted together.

Resistor Values
The omega symbol often used to represent resistance is not used in this publication.
- Whole-number resistor values below 1000 ohms are suffixed with "R", for example: 820R.
- Whole-number resistor values above 1000 ohms are suffixed with "K", for example: 820K.
- Fractional resistors values have "R" or "K" inserted at the position of the decimal point, for example: 8R2 represents 8.2 ohms, 1K0 represents 1K ohms.