Keyless Start Control Module: Service and Repair

Start Control Unit

Removal
1 Remove the rear seat armrest. For additional information, refer to Rear Seat Armrest Rear Seat Armrest
2 Remove the floor console veneer trim panel. For additional information, refer to Floor Console Finish Panel Floor Console Finish Panel




3 Remove the floor console rear panel.
- Carefully release the 2 clips.




4 Remove the floor console side panel trim.
- Remove the 2 Torx bolts.
- Carefully release 11 clips.
- Repeat the procedure and remove the opposite hand.




5 Remove the keyless start control module trim cover.
- Remove the 2 Torx screws.




6 Remove the keyless start control module.
- Remove the 2 Torx screws.
- Disconnect the electrical connector.

Installation
1 Install the keyless start control module.
- Connect the electrical connector.
- Install the Torx screws.
2 Install the keyless start control module trim cover.
- Install the Torx screws.
3 Install the floor console side panel trim.
- Carefully align and secure the clips.
- Tighten the Torx screws to 6 Nm (4 lb.ft).
- Install the opposite hand.
4 Install the floor console rear panel.
- Align the lugs and secure the clips.
5 Install the floor console veneer trim panel. For additional information, refer to Floor Console Finish Panel Floor Console Finish Panel
6 Install the rear seat armrest. For additional information, refer to Rear Seat Armrest Rear Seat Armrest
7 Connect WDS to the vehicle and configure a new module.