Oil Temperature Sensor For ECM: Service and Repair

Oil Temperature Sensor

Removal
1 Remove the cover and disconnect the battery ground cable. For additional information, refer to Specifications [1][2]Battery
2
WARNING: Do not work on or under a vehicle supported only by a jack. Always support the vehicle on safety stands.
Raise and support the vehicle.
3 Remove the engine undershield. For additional information, refer to Radiator Splash Shield Radiator Splash Shield




4 Remove the oil temperature sensor.
- Disconnect the electrical connector.

Installation
1 Install the oil temperature sensor.
- Clean the components.
- Apply sealant of the correct specification to the sensor thread.
- Tighten the sensor to 15 Nm (11 lb.ft).
- Connect the electrical connector.
2 Install the engine undershield. For additional information, refer to Radiator Splash Shield Radiator Splash Shield
3 Connect the battery ground cable and install the cover. For additional information, refer to Specifications [1][2]Battery