Procedure 13 - Replace Roof Sight Shields
REPAIR PROCEDURE 13: V00477 - V075001. Turn ignition 'ON'.
2. Open Panoramic roof opening panel to the full tilt position.
3. Turn ignition 'OFF'.
4. Remove the RH outer sight shield.
^ Note the position and gap between the top of the shield and the roof opening panel.
NOTE:
The sight shields must be installed with the tapered end towards the front of the vehicle.
5. Install the RH outer sight shield.
^ Slide the shield as far forward as possible.
^ Secure the five clips.
6. Repeat steps 1 - 5 to the LH outer sight shield.
7. Turn ignition 'ON'.
8. Open Panoramic roof opening panel to the full-open position.
9. Turn ignition 'OFF'.
10. Remove RH inner sight shield.
CAUTION:
Ensure there is a 2mm gap between the rear of the sight shield and the drive spindle.
11. Install the RH inner sight shield.
^ Secure the rear clip to the rail.
^ Secure the remaining four clips while sliding the shield rearward.
12. Repeat steps 10 - 11 to the LH inner sight shield.
13. Continue to next appropriate Repair Procedure.