Procedure 11 - Remove Cassette Mounting Nuts, Glass Alignment Pegs
REPAIR PROCEDURE 11: V00477- V08100NOTE:
V08101 - V10285 only if full headliner has been lowered.
1. Verify Panoramic roof cassette front and rear mounting studs are centered.
^ Remove the two front mounting nuts.
^ If necessary, use a suitable socket and extension bar to bend the two front mounting studs until centered in the holes
^ Install the two front mounting nuts:
^ Tighten to 5.4Nm (4.0lbf ft).
^ If present, remove and discard the two rear nuts.
^ If necessary, use a suitable socket and extension bar to bend the two rear mounting studs until centered in the holes.
CAUTION:
Ensure the alignment pegs do not protrude through the slot in the body.
NOTE:
Apply a small amount of grease to the inside of the socket to prevent the broken peg from remaining in the vehicle.
2. Use a suitable socket and extension bar to remove the front windshield locating pegs.
CAUTION:
Ensure the alignment pegs do not protrude through the slot in the body.
3. Repeat step 2 to the rear windshield locating pegs.
4. Remove screw (RH) in [A]:
^ Check and remove any glue residue from screw or Panoramic roof cassette.
^ Install screw; tighten to specified torque value.
^ Repeat for LH screw.
^ Tighten screws in [B] to specified torque values.
5. Tighten screws in [C] and [D] to specified torque values.
6. Tighten screws to specified torque value.
7. Continue to next appropriate Repair Procedure.