Hood: Service and Repair

Hood

Special Service Tools






Actuator Aligners - Pedestrian Protection Hood Stops

501-119

Removal





1 With assistance, remove the hood.
- Release the clips and disconnect the struts.
- Remove the 8 nuts.
2
NOTE:
Do not disassemble further if the component is removed for access only.
Remove the hood seal end caps.
- Release from the 4 clips.




3 Remove the hood seal.
- Release the hood seal.
- Remove the 17 clips.




4 Remove the hood pad.
- Remove the 23 clips.




5 Remove the 2 secondary hood pads.
- Remove the 4 clips.

Installation
1 Install the secondary hood pads.
- Secure with the clips.
2 Install the hood pad.
- Secure with the clips.
3 Install the hood seal.
- Install the clips.
- Attach the hood seal.
4 Install the hood seal end caps.
- Secure with the clips.
5 With assistance install and align the hood.
- Tighten the nuts to 25 Nm (18 lb.ft).
- Connect the struts and secure with the clips.




6 Align the hood to the pedestrian protection actuators using special tools 501-119.
- Insert special tools 501-119 into the pedestrian protection actuators.
- Loosen the 8 bolts securing the pedestrian protection actuator stops to the hood.
- Gently close the hood so that the pedestrian protection hood stops are aligned to the actuators.
- Open the hood.
- Tighten the bolts to 10 Nm (7 lb.ft).