Front Fog Lamp

Front Fog Lamp

Removal

NOTE:
Left-hand shown, right-hand similar.
1 Disconnect the battery ground cable. For additional information, refer to Specifications
2
WARNING: Do not work on or under a vehicle supported only by a jack. Always support the vehicle on safety stands.
Raise and support the vehicle.
3 Remove the front wheel and tire. For additional information, refer to Wheel and Tire Service and Repair




4 Release the front of the fender splash shield.
- Remove the 11 Torx bolts.
- Tie the splash shield aside.




5 Remove the front fog lamp.
- Disconnect the electrical connector.
- Remove the 2 Torx screws.

Installation
1 Install the front fog lamp.
- Tighten the Torx screws.
- Connect and secure the electrical connector.
2 Install the fender splash shield.
- Tighten the Torx bolts.
3 Install the wheel and tire. For additional information, refer to Wheel and Tire Service and Repair
4 Connect the battery ground cable. For additional information, refer to Specifications
5
NOTE:
The fog lamp beam should be set at 1.2% below the horizontal and parallel.
Check the fog lamp beam alignment.